Jonsered CS 2240 Manuel d'utilisateur télécharger pdf (Page 7)

8 – English

2.8 General instructions

The workshop where chain saw repairs are to be

done must be equipped with safety equipment as

set out in local provisions.

No one may repair the chain saw unless they have

read and understood the content of this Workshop

Manual.

In this workshop manual the following boxes indi-

cate where caution should be taken.

2.9 Special instructions

The fuel that is used in a chainsaw poses the fol-

lowing hazards:

• The fuel and its fumes are toxic.

• May cause irritation to skin or eyes.

• May cause breathing difculties.

• Highly ammable.

When using compressed air the air jet should

never be pointed at the body. Air can be forced into

the bloodstream and cause fatal injury.

Wear ear protection when testing saws.

After testing a saw do not touch the silencer until

it has cooled down. The silencer gets very hot and

you may burn yourself. Wear protective gloves

when working on the silencer.

The guide bar, chain and clutch cover (chain brake)

must be tted before the saw is started. If not, the

clutch may come loose and cause injury.

Poor chain lubrication can result in failure of the

chain, which could cause serious or fatal injury.

Take care to ensure that the spring inside the

starter assembly does not y out and cause injury.

Wear eye protection. If the spring is under

compression when the pulley is removed it could

y out and cause injury.

Before removing the tensioning spring from the

chain brake, ensure that the brake is in the on

position, otherwise the spring may y out and

cause injury.

After completing the repair the chain brake must be

tested, see “Chain brake – reassembly \ Operating

test”.

Always consider the re risk. A chainsaw can

produce sparks that could start a re.

Inspect the chain catcher and replace it if it is

damaged.

WARNING!

The warning text warns of the risk

of personal injury if the instruc-

tions are not followed.

NOTE!

The warning text warns of the risk of ma-

terial damage if the instructions are not

followed.

Introduction and safety instructions

1 2 3 4 5 6 7 8 9 10 11 12 ... 54 55

Commentaires sur ces manuels

Pas de commentaire

Jonsered CS 2240 Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à chaîne Jonsered CS 2240