Jonsered CS 2240 Manuel d'utilisateur télécharger pdf (Page 51)

52 – English

Repair instructions

7.29 Replacing the bar bolt

Replacing the front bar guide.

Drain the oil tank.

Knock through the old guide bar bolt so that it falls

into the oil tank.

Remove the bolt from the oil tank.

Secure steel wire to the outer part of the bar bolt

(A), thread the steel wire through the oil tank and

out through the bolt hole in the crankcase (see

gure 70).

Pull the steel wire so the bolt comes out of its hole

(see gure 71).

Check that the bolt's square head ts in

the washer (D) which is positioned in the cut-out in

the crankcase.

Pull out the bar bolt with its nut. Place a spacer

between the nut and crankcase (see gure 71).

Rell with chain oil.

Replacing the rear bar guide

Pull out the bar guide (C) with the help of slip-joint

pliers (see gure 70).

Fit the bar guide with the help of a hammer.

Fig 70

Fig 71

1 2 ... 46 47 48 49 50 51 52 53 54 55

Pas de commentaire

Jonsered CS 2240 Manuel d'utilisateur Page 51