Jonsered CS 2240 Manuel d'utilisateur télécharger pdf (Page 22)

English – 23

6.10 Throttle lock, throttle trigger and

return spring – reﬁtting

Lubricate all pins and mating surfaces with a light

oil.

Fit the throttle control (B) and spring (C) (see

gure 22).

Hold the spring and insert the throttle lock into the

cut-out in the handle (see gure 23).

Fit the throttle control pin (E) with the help of a

punch. (see gure 23)

Fit the throttle lock (D) by pressing it onto the shaft

in the handle (see gure 24).

Assemble the handle insert using a screw, when

the throttle control, lever, throttle cable and throttle

control lock with pin are tted correctly (see gure

25).

Safety equipment

Cleaning and inspection

• Clean and inspect all parts carefully. If there are

any cracks or other defects replace the dama-

ged parts with new ones. Always use original

parts.

• Check that the spring is not broken and has not

lost its tension.

Fig 22

Fig 23

Fig 24

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 54 55

Pas de commentaire

Jonsered CS 2240 Manuel d'utilisateur Page 22