Jonsered GC 2125 Manuel de l'opérateur télécharger pdf (Page 25)

English – 25

MAINTENANCE

Two-piece shaft

(GC 2125C)

The drive shaft end in the lower shaft should be lubricated

with grease every 30 hours. There is a risk that the drive shaft

ends (splined coupling) on models with two-piece shafts will

seize if they are not lubricated regularly.

Bevel gear

The bevel gear is ﬁlled with the right amount of grease at the

factory. However, before using the machine you should check

that the bevel gear is ﬁlled 3/4 full with grease. Use

JONSERED special grease.

The grease in the bevel gear does not normally need to be

changed except if repairs are carried out.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Pas de commentaire

Jonsered GC 2125 Manuel de l'opérateur Page 25