Jonsered GT2123 Manuel d'utilisateur télécharger pdf (Page 13)

English – 13

STARTING AND STOPPING

Check before starting

• Check that the trimmer head and trimmer guard are not

damaged or cracked. Replace the trimmer head or

trimmer guard if they have been exposed to impact or are

cracked.

• Never use the machine without a guard nor with a

defective guard.

• All covers must be correctly ﬁtted and undamaged before

you start the machine.

Starting and stopping

Cold engine

Ignition: Set the stop switch to the start position.

Primer bulb: Press the air purge repeatedly until fuel begins

to ﬁll the bulb. The bulb need not be completely ﬁlled.

Choke: Set the choke control in the choke position.

Warm engine

Use the same starting procedure as for a cold engine but

without setting the choke control in the choke position.

Starting

Hold the body of the machine on the ground using your left

hand (CAUTION! Not with your foot!). Grip the starter handle,

slowly pull out the cord with your right hand until you feel

some resistance (the starter pawls grip), now quickly and

powerfully pull the cord. Never twist the starter cord around

your hand.

Repeat pulling the cord until the engine starts. When the

engine starts, return choke control to run position.

CAUTION! Do not pull the starter cord all the way out and do

not let go of the starter handle when the cord is fully extended.

This can damage the machine.

Stopping

Stop the engine by switching off the ignition.

WARNING! The complete clutch cover and

shaft must be ﬁtted before the machine is

started, otherwise the clutch can come loose

and cause personal injury.

Always move the machine away from the

refuelling area before starting. Place the

machine on a ﬂat surface. Ensure the cutting

attachment cannot come into contact with

any object.

Make sure no unauthorised persons are in

the working area, otherwise there is a risk of

serious personal injury. The safety distance

is 15 metres.

WARNING! When the engine is started with

the choke in choke position the cutting

attachment will start to rotate immediately.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Jonsered GT2123 Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Jonsered GT2123